Gently blot until the liquid is completely absorbed.
Blood stains on a maroon carpet.
Mix one tablespoon of scent free liquid hand dishwashing detergent with two cups of.
Mix 1 tablespoon of hand dishwashing liquid with 2 cups of cold water.
If you don t have a spray bottle instead pour on just enough water to wet the carpet.
Do not use warm or hot water which can set the blood stain permanently into the carpet.
But may not completely get rid of old stains.
Using your cloth or rage blot away remember no rubbing the baking soda paste and it will lift the blood stain with it.
The truth is that if blood is left to dry for more than a few days that stain may never go away.
You may be able to fade it out but it may never go away.
The solutions mentioned work on newer stains.
Especially if your carpet s color is on the lighter side.
Repeat until the blood stain on the carpet.
Use a wet vac to suck out the remaining moisture if you don t have a wet vac use a dry towel to blot the stain.
For this methods mix 1 2 teaspoons of ammonia with water and apply the solution to the carpet.
Sponge the blood stain with a clean cloth sodden in the detergent solution to get the blood out of your carpet.
Note that these are harsher methods that could damage your carpet so remember to always test a small area before applying the solutions to the blood stain.
You can then follow these few steps to know how to remove blood stains from your carpet.
Once you are done drip a little bit of water on the remaining baking soda and blot it up.
Spray the cold water onto the blood stain.
The first step say pros is to brush or scrape the area to loosen the blood.
Spray the stain with cold water and let it sit a few minutes.
After vacuuming the bits apply cold water and blot until the stain fades or disappears.
This will prevent the blood stain from spreading and bleeding onto a larger area of the carpet.
Using a mixture of water and ammonia can be an effective way to remove blood stains from a carpet but remember to never use ammonia on woolen carpets.
Spray with cold water.
If that doesn t work some pros recommend using solutions that vary depending on the carpet material.
Detergent solution if the stain has dried gently go over it with a soft brush to break up the deposit.
Let it soak in for five to ten minutes then blot well with a cloth or towel.
Avoid hot water as it would make the stain set in and way more difficult to remove blood from a carpet.
Use clean areas of the towel if it is getting too wet and messy.
